Tea Plucking Machine is a Machine used for picking Tea, which is now widely used in tea cultivation. The Tea Plucking Machine is easy to malfunction due to improper operation. In order to make you have a higher efficiency of Tea picking, Tea Plucking Machine manufacturers have sorted out the faults and troubleshooting methods that are prone to tea Plucking Machine for you, you can know about it.

Tea Plucking Machine is a crop harvester that plucks fresh tea from the top of the tea tree. The working principle of the Tea Plucking Machine is roughly divided into two methods. One method uses the bending principle to plucking fresh tea leaves while retaining the coarse and old branches. Another method is to keep the old and young leaves while using a pair of elastic fingers to hold the tea, relying on the static friction between the fingers and the tea to pick new leaves. Because of its low production efficiency and high requirements for tea garden management, the technology of selective tea picking has not been widely promoted. Therefore, at present, Tea Plucking Machine is mostly used, which uses the principle of shearing to pick tea. Its structure is simple and easy to use, so it is very popular.

A stop failure occurred while running

At this time, the smile on the farmer's face gradually faded. But don't worry, our techs will take care of everything. If it turns off suddenly, it may be due to a lack of power. After checking, charge it on. There may be a short circuit in the lithium battery, which needs to contact the lithium battery manufacturer for verification, the manufacturer needs to troubleshoot and repair, and can not be disassembled by itself.

A fault that cannot be started

In case of failure to start, first check whether the power is sufficient. And check whether the fastener is loose, if it is loose, it should be tightened. It could be a blockage. Clean it out. The technician also said it was probably because the battery was in poor contact. If there is a problem, you can replace the lithium battery can be replaced.

underpower

The lack of power is mainly manifested in the engine, and can not pick tea. The main reason for this kind of failure is that the battery has been placed for a long time without maintenance, resulting in overdischarge of the battery, and thus the performance is reduced. There is also a possibility of blockage, which needs to be removed for cleaning.

Uneven cutting

Mainly due to the running speed is too low, the knife edge clearance is too large, and the blade is worn and blunted. Must be replaced in time.

Tea Plucking Machine https://www.keylead.cn/Electrical-Tea-Plucking-Machine